Co Line - Incoming Ringing Assignment; Co Line Ringing Assignments - Vodavi STARPLUS Triad-S Manual

CO Line - Incoming Ringing Assignment

6. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
CO Line - Incoming Ringing Assignment
Description
Each CO line may be programmed (in database admin) so that incoming ringing on the
specified CO line(s) may be assigned initial ringing to one of the following destinations:
One or more stations (Keyset or SLT)
An ACD, UCD, Voice Mail or Hunt Group
Off-Net (via Speed Dial)
The ring-in follows Day Ring assignments unless Night Service mode is active, in which case
all incoming CO calls follow Night Ring assignments.
When ringing is assigned to a keyset, a direct line appearance or an idle LOOP button must be
available to receive the call. Station call forwarding of the initial ringing CO call is possible
and can be directed to other keysets with an available LOOP button or direct appearance.
If the initial ringing CO call cannot ring at the destination assigned, the call rings at the
first Attendant station.
If all ringing assignments are deleted, calls continue to ring at Station 100.

CO Line Ringing Assignments

Description
Each CO Line may be assigned to ring any station in the system; UCD, Voice Mail or Hunt
Group, or Off-Net (via speed dial). CO Line ringing is programmed on a per CO Line
destination basis. Each destination may be designated to ring during the day, during the
night, or receive both Day and Night ringing. Stations that are assigned for initial ring-in
must have a LOOP button(s) to answer calls if a direct CO appearance is unavailable.
An incoming CO line may be programmed to any number of stations but it cannot be
programmed to ring a mixture of stations and groups in the same time period. Incoming calls
directed Off-Net are connected to an outgoing system speed bin. CO lines assigned to ring
multiple stations do not follow any station's forwarding.
If an error is made while entering digits, press HOLD to save the erroneous entry.
Key in digits over the old name; if excess characters remain, use the digits [11] to
transpose spaces over the undesired characters.
Chapter 2 - Features and Operation
2-69