Setting The Email Server - Epson DS-790WN Administrator's Manual

Authentication Settings
2. Select Start.
The connection test is started. After the test, the check report is displayed.
LDAP Server Connection Test References
Messages
Connection test was successful.
Connection test failed.
Check the settings.
Connection test failed.
Check the date and time on your
product or server.
Authentication failed.
Check the settings.
Cannot access the product until
processing is complete.

Setting the Email Server

When you use Scan to My Email, set Email Server.
Note:
You can set Scan to My Email only when Scan to Email has been enabled.
When setting up from Web Config:
Select the Network tab > Email Server > Basic.
When setting up from Epson Device Admin:
Select Common > Email Server > Mail Server Settings from the configuration template.
Item
Authentication Method
>
Registering and Setting Information
This message appears when the connection with the server is successful.
This message appears for the following reasons:
❏ The LDAP server address or the port number is incorrect.
❏ A timeout has occurred.
❏ Do Not Use is selected as the Use LDAP Server.
❏ If Kerberos Authentication is selected as the Authentication Method,
settings such as Realm (Domain), KDC Address and Port Number (Kerberos)
are incorrect.
This message appears when the connection fails because the time settings for the
scanner and the LDAP server are mismatched.
This message appears for the following reasons:
❏ User Name and/or Password is incorrect.
❏ If Kerberos Authentication is selected as the Authentication Method, the
time/date may not be configured.
This message appears when the scanner is busy.
Specify the authentication method for the scanner to access the mail server.
Off
SMTP AUTH
POP before SMTP
141
>
Setting the Email Server
Explanation
Settings and Explanation
Authentication is disabled when communicating with a mail
server.
The email server needs to support SMTP authentication.
When you select this item, set a POP3 server.