Checking A Mail Server Connection - Epson DS-790WN Administrator's Manual

Required Settings for Scanning
Items
Secure Connection
Certificate Validation
POP3 Server Address
POP3 Server Port Number

Checking a Mail Server Connection

You can check the connection to the mail server by performing the connection check.
1. Access Web Config and select the Network tab > Email Server > Connection Test.
2. Select Start.
The connection test to the mail server is started. After the test, the check report is displayed.
Note:
You can also check the connection to the mail server from the control panel. Access as below.
Settings > Network Settings > Advanced > Email Server > Connection Check
Mail Server Connection Test References
Messages
Connection test was successful.
SMTP server communication error.
Check the following. - Network
Settings
>
Configuring a Mail Server
Specify the secure connection method for the email server.
None
SSL/TLS
STARTTLS
The certificate is validated when this is enabled. We recommend this is set to Enable.
If you select POP before SMTP as the Authentication Method, enter the POP3 server
address between 0 and 255 characters using A-Z a-z 0-9 . - . You can use IPv4 or FQDN
format.
If you select POP before SMTP as the Authentication Method, enter a number between 1
and 65535.
This message appears when the connection with the server is successful.
This message appears when
❏ The scanner is not connected to a network
❏ SMTP server is down
❏ Network connection is disconnected while communicating
❏ Received incomplete data
>
Checking a Mail Server Connection
Settings and Explanation
If you select POP before SMTP in Authentication Method,
the connection method is set to None.
This is available when Authentication Method is set to Off
or SMTP AUTH.
This is available when Authentication Method is set to Off
or SMTP AUTH.
Cause
41