Configuring Group Policy - Epson DS-790WN Administrator's Manual

Advanced Security Settings
❏ Algorithm Settings
It is recommended that you select Any for all settings or select an item other than Any for each setting. If you
select Any for some of the settings and select an item other than Any for the other settings, the device may not
communicate depending on the other device that you want to authenticate.
Items
IKE Encryption
Authentication
Key Exchange
ESP Encryption
Authentication
AH Authentication

Configuring Group Policy

A group policy is one or more rules applied to a user or user group. The scanner controls IP packets that match
with configured policies. IP packets are authenticated in the order of a group policy 1 to 10 then a default policy.
1. Access Web Config and then select the Network Security tab > IPsec/IP Filtering > Basic.
2. Click a numbered tab you want to configure.
3. Enter a value for each item.
4. Click Next.
A confirmation message is displayed.
5. Click OK.
The scanner is updated.
Group Policy Setting Items
Items
Enable this Group Policy
Access Control
Configure a control method for traffic of IP packets.
>
Encrypted Communication Using IPsec/IP Filtering
Settings and Explanation
Select the encryption algorithm for IKE.
The items vary depending on the version of IKE.
Select the authentication algorithm for IKE.
Select the key exchange algorithm for IKE.
The items vary depending on the version of IKE.
Select the encryption algorithm for ESP.
This is available when ESP is selected for Security Protocol.
Select the authentication algorithm for ESP.
This is available when ESP is selected for Security Protocol.
Select the encryption algorithm for AH.
This is available when AH is selected for Security Protocol.
Settings and Explanation
You can enable or disable a group policy.
104
>
Configuring Group Policy