Mitel 3300 Technician's Handbook page 178

Technician's Handbook
Table 41. Troubleshoot Alarms
Alarm
E2T ICP Com
E2T ICP Com
DSP
DSP
DSP
160
Probable Cause
DHCP is corrupted.
Incorrectly
programmed E2T IP
address or setup via a
debug cable.
Programmed 30 voice
mail ports, but
required DSP Module
not installed (does not
apply to 700-user
Controller).
Programmed
compression
channels, but required
DSP Module(s) not
installed.
DSP Module(s) for
compression installed,
but license not
enabled.
Corrective Action
Rebuild the DHCP
scope.
Verify that E2T
VxWorks parameters
are correct (see
"Programming the
E2T via a Debug
Cable" on page 135).
Install required DSP
Module (see "Add a
DSP Module for 30
Voice Mail Ports" on
page 90).
Install required DSP
Module(s) ("Adding
Compression
Channels" on
page 91).
Enable compression
license in ESM
(System Configuration
/System Capacity/
License and Option
Selection).