Mitel 3300 Technician's Handbook page 123

If you get an error message see
Note:
"Troubleshooting Software Installation and
Upgrade" on page 147.
Setting your purchased Mitel options
29. Start Internet Explorer, and go to the IP address of
the 3300 Controller (for example, http://<RTC IP
address>). You see the 3300 ICP ESM login page.
Note: Your laptop/PC must have the same subnet
address as the RTC IP (for example, 192.168.1.x, where
x is a variable) to launch ESM.
30. Log in to the 3300 ICP ESM using the default
username (system) and password (password). You
see the 3300 ICP ESM main tools menu.
Tip: If your login fails, it may be because the system is
not finished loading. Once you see Channel 19
initialized in the RTC (Channel 29 initialized if you
have 30 voice mail ports), you should be able to log in.
31. Set the options in the License and Option Selection
form according to your purchased Mitel options.
Note: Since the installation of new software erases all of
your system settings, you must complete this form even
if you have not purchased any new options.
To set the options:
• At the main tools menu, click System
Administration Tool.
• Click in the Selection: drop-down menu, where it
says [Click here to start].
• Click System Configuration, click System
Capacity, and then click License and Option
Selection. You see the License and Option
Selection view.
• Click Change in the top right corner. You see a
pop-up window.
• Click OK to proceed to change your options.
(Clicking Cancel will return you to the License and
Option Selection view.)
Upgrade and FRUs
105