Mitel 3300 Technician's Handbook page 125

The system takes approximately 20 minutes
Time:
to restore an average-sized database, during which
time the files are copied to the 3300 Controller.
Once the files have been copied, you must reset
the controller. Note that the system can take up to
an additional 1 hour to reset.
39. When the system has finished resetting, log back in
to ESM (using the customer's username and
password).
40. Click System Administration Tool, click
Maintenance and Diagnostics, click
Maintenance Commands, then click All.
41. Issue the dbms stat command to check if the DBMS
flag (DBMS_INITIALIZED) is ON.
42. Issue the Type*.dr.logfile_1 command to display the
log file created during the Data Restore. Wait until the
checks are complete
Peforming the final reboot
43. Verify that none of the NSUs are loading. If they are,
wait until they have finished loading (L0/L1 LEDs are
not marching).
44. If you have upgraded from 20 to 30 voice mail ports,
program the new voice mail ports.
45. Manually reset the controller again to ensure that all
the components are properly initialized.
Performing maintenance checks
Do not reset any system components (Controller, NSU,
ASU, DSU, Peripheral Unit, and so on) while executing
the following checks.
46. When the system has finished resetting, log back in
to ESM (using the customer's username and
password).
Upgrade and FRUs
107