Mitel 3300 Technician's Handbook page 124

Technician's Handbook
Restoring the database
32. In the Selection: drop-down menu, click
33. Type the location of the database that is being
34. Click Start Restore. A window warns you that you
35. Click OK. The system will show an "in progress"
36. Click OK.
37. Click the Exit button until you are logged out of ESM.
38. Manually reset the system by pressing the Reset
106
• Enter the purchased system options. Note that you
can change the Country, Networking Option,
MiTAI/Tapi Computer Integration, and Extended
Agent Group fields without a new Mitel Options
Password (enable these options as needed).
In the Configuration Options section, we
Note:
recommend that you enable Networking Option and
Mitai/Tapi Computer Integration.
• Enter your Mitel Options Password, and click Save.
A pop-up window instructs you, "If you have a
database to restore, do that now. If there is no
database to restore, reboot now." Click OK to close
the window, and continue below.
Timer: The system can take up to 3 minutes to save
your changes.
Maintenance and Diagnostics and then click
Restore.
restored, or use the browse facility.
must manually reboot after a restore and that a
restore replaces the current database.
message and then a "complete" message.
button on the 3300 Controller.
Note: The system does not allow you to log in during the
restore and reset period. Once the system has completed
the restore and reset, you should see
"deleting/ipservicesdb.tar" in the RTC. This is a good
indication that you can log back in to the 3300 ESM.