Adjust (Adjustment Mode) - Canon imageRUNNER ADVANCE C3330 Series Service Manual

ADJUST (Adjustment mode)

■ ADJ-XY
COPIER (Service mode for copier) > ADJUST (Adjustment mode) > ADJ-XY
ADJ-X 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
ADJ-Y 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj of img pstn in book mode: vert scan
To adjust the image reading start position (image lead edge position) in vertical scanning direction.
When replacing the Scanner Unit/clearing the RAM data of the Reader Unit, enter the value of
service label.
When the non-image width is larger than the standard value, set the smaller value.
When out of original area is copied, set the larger value.
As the value is incremented by 1, the image position moves to the trailing edge side by 0.1 mm.
- When replacing the Scanner Unit
- When clearing the RAM data of the Reader Unit
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-50 to 50
mm
0
0.1
Adj of img pstn in book mode: horz scan
To adjust the image reading start position in horizontal scanning direction.
When replacing the Scanner Unit/clearing the RAM data of the Reader Unit, enter the value of
service label.
When the non-image width is larger than the standard value, set the smaller value.
When out of original area is copied, set the larger value.
As the value is incremented by 1, the reading position moves to the front side by 0.1 mm.
- When replacing the Scanner Unit
- When clearing the RAM data of the Reader Unit
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-50 to 50
mm
0
0.1
718
8. Service Mode