6. Remove the ITB [1].
CAUTION:
Points to Note at Installation:
Install the ITB by inserting paper between the belt and the frame as shown in the figure below.
• A new ITB comes with dedicated paper.
Be sure that the rib of the ITB is not placed on the Tension Roller.
NOTE:
• Parts Counter : COPIER > COUNTER > DRBL-1 > TR-BLT
• It is also cleared at the same time when TR-UNIT is cleared.
• After installation, execute [Auto Adjust Gradation> Full Adjust], [Auto Correct Color Mismatch].
Removing the Primary Transfer Roller (Y/M/C/BK)
■ Preparation
1. Remove the ITB
Unit."Removing the ITB" on page 329
4. Parts Replacement and Cleaning
333
[1]