Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1077

Card Reader
● For TYPE-1 (When installing the Copy Card Reader and the Voice Guidance Kit at the
same time.)
1. Securing the Cable of the Voice Guidance
1. Remove the covers of the 4 Cord Guides, and affix the Cord Guides to the position as shown in the figure.
2. Insert only the Speaker Cable through the 4 Cord Guides.
3. Install the 4 Cord Guide Covers.
2. Securing the Cable of the Copy Card Reader
1. Remove the covers of the 2 Cord Guides, and affix the Cord Guides to the position as shown in the figure. (Use the
Cord Guides (thick) included with the Copy Card Reader.)
2. Remove the Face Seal, and install the Wire Saddle. (included with the Copy Card Reader).
3. Fold the Copy Card Reader Cable at the [A] part, and insert only the Copy Card Reader Cable through the 2 Cord
Guides and then secure it in place with the Wire Saddle.
4. Install the 2 Cord Guide Covers.
CAUTION:
• Do not cover the Exhaust Outlet with the Cord Guide.
• Do not affix a Cord Guide on the Reader Cable Cover.
● For TYPE-2 (When installing the Copy Card Reader and the Voice Operation Kit at the
same time.
1. Securing the Cable of the Voice Operation Kit
1. Remove the covers of the 7 Cord Guides, and affix the Cord Guides to the position as shown in the figure.
2. Insert only the DVI Cable through the 7 Cord Guides.
3. Install the 7 Cord Guide Covers.
2. Securing the Copy Card Reader Cable
1. Remove the covers of the 2 Cord Guides, and affix the Cord Guides to the position as shown in the figure. (Use the
Cord Guides (thick) included with the Copy Card Reader.).
2. Remove the Face Seal, and install the Wire Saddle. (included with the Copy Card Reader).
3. Fold the Copy Card Reader Cable at the [A] part, and insert only the Copy Card Reader Cable through the 2 Cord
Guides and then secure it in place with the Wire Saddle.
Voice Guidance Kit
TYPE-1
Wire Saddle
7x
1065
Voice Operation Kit
TYPE-2
Reader Cable Cover
[A]
[B]
Exhaust Outlet
9. Installation