3* Adjust (Adjustment Mode) - Canon GP200 Service Manual

F. *3* ADJUST (adjustment mode)
• Use this mode to fine-adjust or set back-up data needed for copying operations.
• Each press on the
hand, brings up the previous screen.
• Press the item you want to adjust or set (notation) to highlight.
• Use the keypad to enter numbers.
• Press the
OK
• Record all new settings on the service label.
• When done, turn off and then on the main power switch.
1. Fine-Adjusting and Entering the Multifeeder Paper Width Basic Setting
Item
Use it to fine-adjust or enter the multi-
feeder paper width basic setting.
MF-A6R MF-A6R: Indicates the stored A6R
MF-A4R MF-A4R: Indicates the stored A4R
MF-A4 MF-A4: Indicates the stored A4
COPYRIGHT © 1996 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
key brings up the next screen; each press on the
key to accept the selected setting.
*3* ADJUST 01
MF-A6R : xxxxx <– (xxxxx)
MF-A4R : xxxxx <– (xxxxx)
MF-A4 : xxxxx <– (xxxxx)
Description
(105mm) value of the multifeeder
paper width sensor.
(210mm) value of the multifeeder
paper width sensor.
(297mm) value of the multifeeder
paper width sensor.
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
CANCEL
+
–
OK
Remarks
If you have replaced the image
processor PCB, be sure to
enter the value recorded on
the service label.
For how to enter a new value
after replacement of the paper
width sensor, see service
handbook p. 2-15.
3. OPERATIONS AND TIMING
key, on the other
Settings
0~65535
3–197