Removing The Developing Unit - Canon imageRUNNER ADVANCE C3330 Series Service Manual

Removing the Developing Unit

■ Preparation
CAUTION:
If you perform work while in Deep sleep mode or when the power was turned OFF while in Deep sleep mode, the Primary
Transfer Roller will not be disengaged.
When removing the Drum Unit (Bk), be sure to do so after returning the machine to a standby state.
1. Remove the Drum Unit."Removing the Drum Unit" on page 318
■ Procedure
1. Remove the screw [1].
• 1 Screw [1]
2. Pull out the Developing Unit [1] to the position in the figure below, disconnect the connector [2], and hook it on the
groove in the Front Inner Upper Cover [3].
• 1 Connector [2]
1x
1x
[2] [1]
4. Parts Replacement and Cleaning
[1]
1x
[3]
319
[2]