Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1004

SORTER (Service mode for delivery options) > FUNCTION (Operation / inspection mode)
MTR-CHK 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
MTR-ON 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
Select motor to check operate
To specify the motor to operate.
- When checking whether there is any failure in the motor
- When checking the operation of the replaced motor
Enter the value, and then press OK key.
When setting the staple motor (Fin-U1/G1) and the stitcher motor (front/rear) (Fin-U1), remove the
staple cartridge. When the staple cartridge is installed, the motor is not driven.
Fin-U1: 1 to 24
Fin-G1: 1 to 11
1: Inlet motor (Fin-U1)/Feed motor (Fin-G1)
2: Front aligning plate motor (Fin-U1)/Return belt motor (Fin-G1)
3: Rear aligning plate motor (Fin-U1)/Front alignment motor (Fin-G1)
4: Rear end assist motor (Fin-U1)/Rear alignment motor (Fin-G1)
5: Stapler shift motor (Fin-U1)/Assist motor (Fin-G1)
6: Staple motor (Fin-U1)/Stapler shift motor (Fin-G1)
7: Tray1 shift motor (Fin-U1)/Paddle motor (Paddle up/down) (Fin-G1)
8: Tray2 shift motor (Fin-U1)/Paddle motor (Paper retainer up/down) (Fin-G1)
9: Stack ejection motor (Fin-U1)/Stapler motor (Fin-G1)
10: Swing motor (Fin-U1)/Clinch motor (Fin-G1)
11: Shutter operation (Stack ejection motor and shutter clutch) (Fin-U1)/Tray shift motor (Fin-G1)
12: Stack ejection lower roller operation (Stack ejection motor and Stack ejection lower roller
clutch) (Fin-U1)
13: Saddle feed motor (Fin-U1)
14: Saddle inlet motor (Fin-U1)
15: Saddle paper folding motor (Fin-U1)
16: Saddle guide motor (Fin-U1)
17: Saddle paper positioning plate motor (Fin-U1)
18: Saddle alignment motor (Fin-U1)
19: Stitcher motor (rear) (Fin-U1)
20: Stitcher motor (front) (Fin-U1)
21: Saddle paper pushing plate motor (Fin-U1)
22: Buffer pass feed motor (Fin-U1)
23: Buffer pass power supply cooling fan (Fin-U1)
24: Buffer pass cooling fan (Fin-U1)
1
SORTER> FUNCTION> MTR-ON
Motor operation check
To start operation check of the motor specified by MTR-CHK.
The motor operation is stopped automatically after 10 seconds.
- When checking whether there is any failure in the motor
- When checking the operation of the replaced motor
Select the item, and then press OK key.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
SORTER> FUNCTION> MTR-CHK
992
8. Service Mode