Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1007

SORTER (Service mode for delivery options) > OPTION (Specification setting mode)
STCR-DWN 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
PRCS-SP3 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
NSRT-STC 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
THN-TRSW 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Set occasional misalign prev mode:Fin-U1
To set ON/OFF of occasional misalignment prevention mode.
When 1 is set, the rise amount of roller at the staple sort delivery of thin/plain paper by the swing
height detection control is decreased. (so the distance between the roller and paper shrinks.)
When misalignment in feed direction occurs occasionally at the staple sort delivery of thin/plain
paper
Enter the setting value, and then press OK key.
0 to 1
0: OFF, 1: ON
0
Set the feed speed to Proc Tray: Fin-U1
To set the feeding speed of the paper to the Processing Tray in the staple mode.
As the value is increased by 1, the feeding speed is decelerated by 50 mm/sec.
When misalignment (buckling on the trailing edge) occurs in staple mode owing to returning the
paper too much.
Enter the setting value, and then press OK key.
Adjust the return amount of the paper on the Processing Tray again with PRCS-RET as needed.
0 to 8
0: 700 mm/s, 1: 650 mm/s, 2: 600 mm/s, 3: 550 mm/s, 4: 500 mm/s, 5: 450 mm/s, 6 to 8: 450 mm/
s
mm/s
0
SORTER> ADJUST> PRCS-RET
50
Set stck improve at non-collate: Fin-U1
To set ON/OFF of stack improvement mode in non-collate mode.
When 1 or 2 is set, paper stack is delivered via the Processing Tray even if it is in non-collate mode
so the stacking condition can be improved.
When the stacking condition at non-collating is poor
Enter the setting value, and then press OK key.
0 to 2
0: Not pass through the Processing Tray, 1: Pass through the Processing Tray at 2-sided print, 2:
Pass through the Processing Tray
1
Set small width ppr delvry destn: Fin-U1
To set the delivery destination of paper which width direction is 139.6 mm or less.
When 1 is set, the following paper which width direction is 139.6 mm or less is delivered to the tray
of the host machine.
- Thin (52 to 63g/m2)/Plain 1 (64 to 75g/m2)/Recycled 1 (64 to 75g/m2)/Tracing (64 to 99g/m2)/
Pre-Punched (64 to 75g/m2)
When the delivery stationary jam occurs at the time of delivering small width paper to the
downstream connection equipment
Enter the setting value and press OK key.
When the stack paper of the host machine's tray is full, the paper is delivered to the downstream
connection machine even if the setting is 1.
0 to 1
0: Delivery destination specified in Control Panel menu, 1: Tray of the host machine
0
995
8. Service Mode