Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1009

SORTER (Service mode for delivery options) > OPTION (Specification setting mode)
MSTP-WT 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
TRY-PSTN 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
TRY-CRNT 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
PADL-TM 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Set wait time after manual staple:Fin-G1
To set the duration of time to keep manual staple mode enabled after execution of manual stapling.
While manual stapling mode is enabled, other jobs are not accepted.
Upon user's request
Enter the setting value, and then press OK key.
0 to 10
sec
0
1
Set tray pstn after job complete: Fin-G1
To set the tray position after the completion of job.
When 1 is set, the tray stops at the lower limit position. Visibility of the delivered papers is improved,
but FCOT becomes longer.
Upon user's request (to improve visibility of the delivered papers)
Enter the setting value, and then press OK key.
When 1 is set, FCOT becomes longer.
0 to 1
0: Normal (priority on productivity), 1: Lower limit position (priority on visibility)
0
COPIER> OPTION> USER> TRY-STP
When 1 in COPIER> OPTION> USER> TRY-STP is set, the tray of the inner finisher does not
down after paper full detection.
Set Stack Tray drive current VL: Fin-U1
To set the drive current value to lift the Stack Tray with a stack of papers which paper weight is
less than the equivalent of 500 sheets of small size paper.
When 1 is set, the current value increases, so the drive torque is increased.
When stacking thin and high density papers
Enter the setting value, and then press OK key.
When 1 is set, operating noise of the Stack Tray becomes louder.
0 to 1
0: Weak (normal), 1: Strong
0
Set ppr rtn time extsn: 2-sided, Fin-G1
To set whether to extend paper pull-back time at 2-sided print.
When 1 is set, paper pull-back time becomes 550 msec longer in the case of 2-sided printing using
plain paper 1 or larger size paper.
When paper pull-back failure occurs at high-density full-color 2-sided printing
Enter the setting value, and then press OK key.
When 1 is set, productivity is decreased.
0 to 1
0: OFF, 1: ON
0
997
8. Service Mode