Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1005

SORTER (Service mode for delivery options) > FUNCTION (Operation / inspection mode)
SL-CHK 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
SL-ON 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
CNT-FCON 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
FR-ST-RP 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Supplement/Memo
CL-CHK 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Select solenoid to check operate: Fin-U1
To specify the solenoid to operate.
- When checking whether there is any failure in the solenoid
- When checking the operation of the replaced solenoid
Enter the value, and then press OK key.
1 to 5
1: Buffer roller separation solenoid
2: Saddle inlet flapper solenoid
3: Saddle No.1 flapper solenoid
4: Saddle No.2 flapper solenoid
5: Saddle feed plate contact solenoid
1
SORTER> FUNCTION> SL-ON
Solenoid operation check: Fin-U1
To start operation check of the solenoid specified by SL-CHK.
- When checking whether there is any failure in the solenoid
- When checking the operation of the replaced solenoid
Select the item, and then press OK key.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
SORTER> FUNCTION> SL-CHK
Parts Counter clear: Finisher
To clear the parts counter that the Finisher Controller PCB counts.
When clearing the parts counter of the Finisher
Select the item, and then press OK key.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
Ppr dust remov at stpl free stpl: Fin-G1
To remove paper dust from the stapler, the stapler repeatedly executes the staple free stapling
operation 30 times without paper.
When this item is executed, performance of the staple free stapler is recovered.
When performance of the staple free stapler is deteriorated
Select the item, and then press OK key.
During operation: ACTIVE, At normal termination: OK, At abnormal termination: NG
The removed paper dust accumulates on the lower frame under the paper path, so it does not
influence to the machine performance.
The part counter value of the staple free stapling operation is counted.
Select clutch to check operate: Fin-U1
To specify the clutch to operate.
- When checking whether there is any failure in the clutch
- When checking the operation of the replaced clutch
Enter the value, and then press OK key.
1 to 2
1: Shutter clutch, 2: Stack ejection lower roller clutch
1
SORTER> FUNCTION> CL-ON
993
8. Service Mode