Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1008

SORTER (Service mode for delivery options) > OPTION (Specification setting mode)
SWGUP-SW 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
MSTP-TMG 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Additional Functions
Mode
Supplement/Memo
Amount of Change per
Unit
DWCL-BND 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
FR-ST-PO 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Swing Unit diseng oprtn:1st thin, Fin-U1
To set whether the Swing Unit performs disengagement operation when feeding the 1st sheet of
thin paper.
By selecting 1, the Swing Unit is disengaged when the 1st sheet of thin paper with 210 mm or less
in width and 297 mm or less in length is fed.
When corner bend or delivery failures occur on the 1st sheet of thin paper.
Enter the setting value, and then press OK key.
When 1 is set, productivity decreases.
0 to 1
0: OFF, 1: ON
0
Setting of manual staple timing: Fin-G1
To set the duration of time before executing automatic stapling at manual staple mode.
As the value is changed by 1, the time is changed by 1 second.
+: Timing is delayed
-: Timing becomes earlier
Upon user's request
Enter the setting value, and then press OK key.
1 to 5
sec
3
Adjustment/Maintenance> Adjust Action> Time Unitil Stapling Starts in Stapler Mode
The setting of the service mode links the setting of the user mode.
1
Set the lead edge bend prev mode: Fin-U1
To set ON/OFF of leading edge corner bend prevention mode for downward curled paper.
By selecting 1, the Alignment Plate is moved inward when a leading sheet of a job is fed while
there is no paper on the Processing Tray. Paper is fed on the Alignment Plate so it can prevent
corners of the leading edge of paper from interfering with the rib of the Processing Tray.
When corners of the leading edge of downward curled paper is bent
Enter the setting value and press OK key.
When 1 is set, the Alignment Plate moves at staple/offset and collate mode so productivity is
decreased.
0 to 1
0: OFF, 1: ON
0
Set staple free staple position: Fin-G1
To set the staple position of staple free stapling.
When 1 is set, staple position becomes the center so paper is more likely to be come off. The
staple position moves to the delivery direction for 4.0 mm and the alignment direction for 2.0 mm
inside.
Upon user's request
Enter the setting value, and then press OK key.
0 to 1
0: Corner-stapling (normal), 1: Center-stapling
0
SORTER> ADJUST >FR-STP-X, FR-STP-Y
996
8. Service Mode