Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1076

15.
16. Remove the covers of the 2 Cord Guides, and affix the Cord Guides to the position as shown in the figure.
17. Fold the Card Reader External Relay Cable at the [A] part and pass it through the Cord Guides and Wire Saddle.
18. Install the 2 covers of the Cord Guides.
19. Close the 1 Wire Saddle.
CAUTION:
• Do not cover the Exhaust Outlet with the Cord Guide.
• Do not affix a Cord Guide on the Reader Cable Cover.
20. Connect the power plug to the outlet.
21. Turn ON the main power switch of the host machine.
■ Routing the Cable (when installing this equipment and other options
simultaneously)
• Routing the cable when installing the Copy Card Reader and other options simultaneously is described below.
• Combinations are shown in the following table.
3x
Wire Saddle
1064
Reader
Cable Cover
[A]
Exhaust Outlet
9. Installation