Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1049

2. [Additional Functions] > [Configuration] > [Network] > [TCP/IP Setting] > [IPv4 setting] > [Ping Command]; and enter
the IP address of the PC with the numeric keypad and press Execute key.
• The network is properly connected if the message say "Response from the host".
• If the message say "No response from the host", check the following.
NOTE:
The IP address of the PC can be checked by the following procedure:
Select the following on a Windows PC: Start > Program > Accessory > Command Prompt; and enter "ipconfig" and press Enter
key to display information of the IP address.
● Checking the Network Setting of the Host Machine
1. Select the following: [Additional Functions] > [Configuration] > [Network] > [TCP/IP Setting] > [IPv4 setting] > [IP
address setting]; and write down the address in the IP address field.
2. Select the following: [Additional Functions] > [Configuration] > [Network] > [TCP/IP Setting] > [IPv4 setting] > [Ping
Command]; and enter the IP address.
• The IP address specified in the Host Machine is correct if the message say "Response from the host".
• If the message say "No response from the host", check the following.
NOTE:
When setting the address by manually input, set the Subnet Mask by following the instruction of the administrator.
● Checking Network Function on the Main Controller
Check with the loopback address.
1. Select Settings/Registration > Preferences > Network > TCP/IP Settings > IPv4 Settings > PING command, enter the
IP address "127.0.0.1" with the numeric keypad, and then press "Start" key.
2. When "Response from the host." is displayed, network function of the Main Controller operates normally.
• When "No response from the host." is displayed, the network function of the Main Controller is failed.
• Replace the Main Controller with a properly operating one, and check the connection.
1037
9. Installation