7. Install the Encryption Board.
• 4 Screws (TP; M3x6)
CAUTION:
Installing the screws
Install the screws in the order from (1) to (4).
8. Connect the Power Cable (270 mm; A: HDD-Pow1) and Signal Cable (250 mm; A: HDD-Sig) to the Encryption Board.
• 2 Connectors
9. Pass the other ends of the Power Cable and Signal Cable through the hole in the HDD Frame, and pull them out as
shown in the figure.
4x
TP
M3x6
2x
1148
9. Installation