Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1181

Hide thumbs Also See for imageRUNNER ADVANCE C3330 Series:

Table of Contents

■ Removable HDD Kit-AK2

[1] HDD Slot Unit X 1

[4] R-HDD Label X 1

[7] Power Supply Convert

Setting Before Turning OFF the Power

Be sure to turn OFF the main power after executing this service mode setting. Turning OFF the main power without

executing service mode causes "E602-5001 (mistake in the procedure before installing the HDD Encryption Board)" to

occur when turning ON the main power after installing the Encryption Board. If this error occurs, the HDD needs to be

returned to the non-encrypted state.

1. Execute the following service mode (level 1).

COPIER > Function > INSTALL > HD-CRYP

Check Items when Turning OFF the Main Power

Check that the main power is OFF.

1. Turn OFF the main power switch.

2. Be sure that display in the Control Panel and the lamp of the main power supply are turned off, then disconnect the

[2] Wire Saddle X 2

[5] Conversion Connector

[3] HDD Warning Label

Use 1 of them

[6] SATA Cable X 1

9. Installation

Troubleshooting