I/O; Adjust (Adjustment Mode) - Canon imageRUNNER ADVANCE 715 series Service Manual

■ MISC
COPIER (Service mode for printer) > DISPLAY (State display mode) > MISC
TNRB-IDK 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
SD-INFO 2

I/O

This item is not used because it is intended for R&D.
The I/O information can be found in service mode > SITUATION > Sensor Check.

ADJUST (Adjustment mode)

■ AE
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > AE
AE-TBL 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
■ ADJ-XY
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > ADJ-XY
ADJ-X 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Display of Bk-color Toner Container ID
To display the ID of Bk-color Toner Container that is installed to the machine
When checking whether the barcode ID on the Toner Container is read correctly
N/A (Display only)
28-digit decimal number
For R&D
Adj of text density at image density adj
To adjust text density according to the adjusted image density.
As the greater value is set, text gets darker.
When clearing the RAM data of the Reader
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When clearing the RAM data of the Reader, enter the value of service label.
1 to 9
5
Adj read start pstn: Copyboard,vert scan
To adjust the image reading start position (image leading edge position) in the vertical scanning
direction at copyboard reading.
As the value is incremented by 1, the image position is moved to the trailing edge side by 0.1 mm.
Decrease the value when the non-image width is larger than the standard value.
Increase the value when out of original area is copied.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-30 to 30
mm
0
0.1
376
8. Service Mode