Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1078

4. Install the 2 Cord Guide Covers.
CAUTION:
• Do not cover the Exhaust Outlet with the Cord Guide.
• Do not affix a Cord Guide on the Reader Cable Cover.
Checking after Installation
1. Check the model of the Card Reader in service mode.
• Check that the setting value is "0" in the following service mode (Level 1): COPIER > OPTION > ACC > CR-TYPE.
2. Set the number of card (number of department ID) that can be used with the Card Reader in service mode.
• Set any value in the following service mode (Level 2): COPIER > OPTION > FNC-SW > CARD-RNG.
3. Enter the card number to be used (1 to 2001) in the following service mode (Level 1): COPIER > FUNCTION > INSTALL
> CARD.
• Enter the smallest card number to be used by the user.
• From the entered card number, 1000 cards can be used.
4. Turn OFF and then ON the main power switch to enable the setting value.
5. Insert a card with a card number that has been registered, and check that the machine operates normally.
NOTE:
• Perform the following operations to change the number of cards (departments) after it has been set. In such a case, counter
information for each department is reset.
• Execute the following service mode (Level 1): COPIER > FUNCTION > CLEAR > CARD.
• Turn OFF and then ON the main power switch to enable the setting value.
• After that, perform from step 1.
10x
1066
Reader Cable Cover
Wire Saddle
[A]
Exhaust Outlet
9. Installation