Removing The Waste Toner Drive Unit - Canon imageRUNNER ADVANCE C3330 Series Service Manual

■ Preparation
1. Remove the Registration Guide
2. Remove the ITB Unit."Removing the ITB Unit" on page 325
■ Procedure
1. Remove the Harness Guide [1].
• 1 Connector [2]
• 1 Claw [3]
• 2 Hooks [4]
2. Remove the Patch Sensor Unit [1].
■ Adjustment after Replacement
The following procedure can also be performed in [Service Mode > SITUATION > Parts Replacement > Adjustment During Patch
Sensor Unit Replacement ].
1. Enter the value shown on the label included in the package.
COPIER > ADJUST > DENS > PALPHA-F
COPIER > ADJUST > DENS > PALPHA-R
2. Execute auto gradation adjustment.
3. After executing auto gradation adjustment, see the alarm log to check that 10-0006/10-0007 has not occurred.
When an alarm occurs, perform a remedy according to the instruction of the alarm.

Removing the Waste Toner Drive Unit

■ Preparation
1. Remove the Motor Fan."Removing the Motor Fan" on page 283
Unit."Removing the Registration Guide Unit" on page 384
[1]
335
4. Parts Replacement and Cleaning
1x
[4]
1x
[3]
[1]
[2]