Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1163

4. Initializing HDD
< In case of SST >
1. Start the host machine with download mode in safe mode.
2. Start the SST.
3. Select the model. Then, select [Single] and click [Start].
4. Click [Format HDD].
5. Select [All], and click [Start].
6. Click [Execute Format].
7. The Format is executed.
8. Click [OK].
9. After formatting is completed, select [Shutdown/Restart], and click [Restart].
10. Click [OK]
11. The power of the host machine is turned OFF.
12. Terminate the SST.
13. Disconnect the Cross Ethernet Cable from the machine, and connect the user's network cable to the machine.
<In case of USB flash drive>
1. Connect the USB memory to the PC.
2. Start up SST, and click the USB icon displayed in the target selection screen.
3. Select the drive, the model series, and the version to be written to the USB flash drive, and click [Confirm].
4. Click [Start], and after the version has been written to the USB flash drive, click [OK] and then remove the USB flash
drive.
5. Terminate the SST.
6. Connect the USB memory device to the host machine, and start the host machine with download mode in safe mode.
7. Press keys on the Control Panel in the order shown below.
• Press any keys
• [4] : Clear/Format
• [1] : Disk Format
• [0] : OK
• Press any keys
• [C] : Return to Menu
• [Reset] : Start shutdown sequence
• [0] : OK (The power of the host machine is turned OFF automatically.)
8. Remove the USB flash drive.
9. Turn ON the main power switch.
Checking the Security Version
1. Press the Counter Check key on the control panel.
2. Press the [Check Device Configuration] key appearing on the control panel.
3. Confirm that '2.01' is displayed for the [Canon MFP Security Chip] item indicating the version of the security chip.
If multiple Encryption Boards are installed, the version information for each board is displayed.
CAUTION:
The user can refer to the version displayed in the [Canon MFP Security Chip] item indicating the version of the security
chip to confirm that an Encryption Board that contains a security chip version that has received CC certification is operating
correctly.
Checking the Security Mark
The user can check the security mark displayed on the Control Panel when using the host machine to confirm that security is
being protected. This security mark is displayed only when an Encryption Board is installed and operating normally. The location
where the security mark is displayed is described in the User's Guide as shown below.
< Confirming the Security Mark >
When the HDD Data Encryption Kit is operating normally, a security mark (
screen.
) is displayed on the lower left corner of a panel
1151
9. Installation