Canon imageRUNNER ADVANCE C3330 Series Service Manual page 1198

3. Select the drive, the model series, and the version to be written to the USB flash drive, and click [Confirm].
4. Click [Start], and after the version has been written to the USB flash drive, click [OK] and then remove the USB flash
drive.
5. Terminate the SST.
6. Connect the USB memory device to the host machine, and start the host machine with download mode in safe mode.
7. Press keys on the Control Panel in the order shown below.
• Press any keys
• [4] : Clear/Format
• [1] : Disk Format
• [0] : OK
• Press any keys
• [C] : Return to Menu
• [Reset] : Start shutdown sequence
• [0] : OK (The power of the host machine is turned OFF automatically.)
8. Remove the USB flash drive.
9. Turn ON the main power switch.
Checking the Security Version
1. Press the Counter Check key on the control panel.
2. Press the [Check Device Configuration] key appearing on the control panel.
3. Confirm that '2.01' is displayed for the [Canon MFP Security Chip] item indicating the version of the security chip.
If multiple Encryption Boards are installed, the version information for each board is displayed.
CAUTION:
The user can refer to the version displayed in the [Canon MFP Security Chip] item indicating the version of the security
chip to confirm that an Encryption Board that contains a security chip version that has received CC certification is operating
correctly.
Checking the Security Mark
The user can check the security mark displayed on the Control Panel when using the host machine to confirm that security is
being protected. This security mark is displayed only when an Encryption Board is installed and operating normally. The location
where the security mark is displayed is described in the User's Guide as shown below.
■ < Confirming the Security Mark >
When the HDD Data Encryption Kit is operating normally, a security mark (
screen.
Informing the System Administrator That Installation Is Complete
• When installation is complete, give the following explanation to the system administrator.
• When installation is complete, inform the system administrator that the security functions have been added, and explain the
procedure for checking whether the security functions are enabled.
• This will enable the system administrator to quickly detect when the functions become disabled and request a service call
to correct the error.
■ Checking That Installation Is Complete:
Following the section "Checking the Security Version", display the version information of the security chip from [Check Device
Configuration] on the Control Panel, and show the system administrator that "2.01" is displayed for the [Canon MFP Security
Chip] item.
) is displayed on the lower left corner of a panel
1186
9. Installation