19. Putting the user's External Switch Cable around the Ring Core.
CAUTION:
Be sure to install the Ring Core as close to where the cable is connected as possible.
20. Insert the user's External Switch Cable into the terminal of the Voice Operation Board.
■ Routing the Cable (when installing this equipment and Copy Card Reader
simultaneously)
1. Securing the Cable of the Voice Operation Kit
1. Remove the covers of the 7 Cord Guides, and affix the Cord Guides to the position as shown in the figure.
2. Insert only the DVI Cable through the 7 Cord Guides, and install the 7 Cord Guide Covers.
2. Securing the Cable of the Copy Card Reader
1. Remove the covers of the 2 Cord Guides, and affix the Cord Guides to the position as shown in the figure.
2. Remove the Face Seal, and install the Wire Saddle. (included with the Copy Card Reader).
3. Fold the Card Reader Cable at the [A] part, insert only the Card Reader Cable through the 2 Cord Guides, and then
secure it in place with the Wire Saddle.
1x
1087
9. Installation