System Status Commands; Light Unit; Show Startup-Config; Table 4-21. System Status Commands - Enterasys Matrix-V V2H124-24 Configuration Manual

System Status Commands

Command

light unit

show startup-config

show running-config
show system
show users
show version
light unit
This command displays the unit ID of a switch using its front-panel LED indicators.
Syntax
light unit [unit]
unit - specifies a unit in a switch stack to light the panel LEDs
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
The unit ID is displayed using the port status LED indicators for ports 1 to 8.
When the light unit command is entered, the LED corresponding to the
switch's ID will flash for about 15 seconds.
Example
Console#light unit 1
Console#
show startup-config
Use this command to display the configuration file stored in non-volatile memory that
is used to start up the system.
Default Setting
None
Command Mode
Privileged Exec

Table 4-21. System Status Commands

Function
Displays the unit ID of a switch using its front-panel LED
indicators
Displays the contents of the configuration file (stored in flash
memory) that is used to start up the system
Displays the configuration data currently in use
Displays system information
Shows all active console and Telnet sessions, including user
name, idle time, and IP address of Telnet clients
Displays version information for the system
System Management Commands
Mode
NE, PE 4-59
PE
PE
NE, PE 4-62
NE, PE 4-63
NE, PE 4-64
4
Page
4-59
4-61
4-59