5
Method Parameters
Method Parameters Comprehensive 2D-LC
Set
The content of the
the 1
Table 8
Column name
Time
Mode
Maximum peak duration
(Comprehensive mode
only)
Sampling time (Heartcut-
ting mode only)
Add transfer volume
If the
NOTE
all.
Set
1 To specify when a new segment starts, fill in required time in the time column.
2D-LC - User Guide
2
D Time Segments
2
D Time Segments table specifies when (within the runtime of
st
dimension) the selected 2D-LC mode is active.
2
Definitions
D Time Segments
Description
Specifies when a new segment starts (or ends)
Following options exist:
•
•
•
Only valid in case of trigger mode = peak-based. After that time the
2D-gradient repetition ends regardless of the peak detector state.
Set the time the loop remains in the flow path of the 1
•
•
(This check box is available only for Time based mode)
2
D Time Segments table is empty, no 2D-LC operation will be executed at
2
D Time Segments for Comprehensive mode
After the time defined, the 2D-gradient repetition ends regardless of the peak
detector state.
Time based
The specified time defines the beginning of a time segment.
Peak based
The peak detector is enabled at the specified time.
Off
The time segments ends at the specified time.
Checked:
Valve is switched at the specified time plus the time to deliver the
delay volume
Unchecked
Valve is switched at the specified time
st
dimension.
134