Emulation Mode - Toshiba B-EX6 Series Maintenance Manual

5. SYSTEM MODE

5.15 EMULATION MODE

Contents of EMULATION MODE menu
Menu item
<12>EMULATION MODE
・ OFF
・ AUTO DETECT ON
・ AUTO DETECT ON SET Whether to enable Z-Mode or D-Mode is automatically detected. BASIC system
・ Z MODE ON
・ Z MODE ON SET
・ D MODE ON
NOTES:
1. By turning the EMULATION MODE parameter setting from "OFF" to other setting, the MEDIA LOAD
parameter is automatically set as follows. This can be changed by setting the MEDIA LOAD parameter
again after the Z-MODE is enabled.
Model
B-EX6T1/T3 QM
2. When "AUTO DETECT ON" or "AUTO DETECT ON SET" is selected, the printer starts in the auto
detection mode which automatically determines whether to enable Z-Mode or D-Mode by a first control
character the printer receives. Also, "EMULATION MODE" is displayed on the LCD. After Z-Mode or D-
Mode is selected, mode detection is not performed until the printer power is turned off and back to on.
Mode detection result depending on control character
Control character
SOH
STX
%01
%02
^ (other than ^01 and ^02)
^01
^02
ESC *c
~
Supplementary explanation
(1) Auto detection result follows the above table, regardless of Alternate Control Code Modes setting for D
Mode. For details of Alternate Control Code Modes, refer to Section 5.1 Control Code Command Functions
in D Mode Command Specification (JEA-03767).
(2) In the auto detection mode, the printer may not normally receive data specified by a part of download
~
commands ( DG,
SET.
Disabled.
Whether to enable Z-Mode or D-Mode is automatically detected. BASIC system
mode program screen is not displayed immediately.
mode program screen is displayed immediately.
Z-Mode is enabled. BASIC system mode program screen is not displayed
immediately.
Z-Mode is enabled. BASIC system mode program screen is displayed
immediately.
D-Mode is enabled. BASIC system mode program screen is not displayed
immediately.
MEDIA LOAD parameter setting
ECO
0x01
0x02
0x25, 0x30, 0x31
0x25, 0x30, 0x32
0x5E
0x5E, 0x30, 0x31
0x5E, 0x30, 0x32
0x1B, 0x2A, 0X63
0x7E
~ ~
DU and DY of Z Mode). In this case, set this parameter to Z MODE ON or Z MODE ON
Hex. Mode detection result
D Mode
D Mode
D Mode
D Mode
Z Mode
D Mode
D Mode
D Mode
Z Mode
5-87
EM18-33031
(Revision Date: Nov., 2017)
5.15 EMULATION MODE