Self Print Test And Dump Mode Utilities; Self Print Test And Dump Mode - Toshiba B-FV4D-GL Series Owner's Manual

2. PRINTER SETUP
2.8 Self Print Test and
Dump Mode Utilities
2.8.1 Self Print Test and
Dump Mode
NOTE:
The following commands will
have no effect the test print. D,
AX, XS, Z2;1, Z2;2 (only the AY
command will)
ENGLISH VERSION EO1-33099
These utilities are used to print out a test with details of the printer
settings and set the printer into Dump mode.
1. Turn off the printer power and install a media roll in the printer.
2. Press and hold the [FEED] Button while turning on the printer. The
status lamps (LED 1 and LED 2) will light up in the following order:
Orange  Green  Other colour sequences
3. Release the [FEED] Button when LED 1 lights in orange and LED 2
lights in green.
4. Press the [FEED] button.
5. The printer prints the self print test, and then enters Dump Mode.
6. To return to Online operation, turn the printer off, then on again.
B-FV4D-G PRINTER INFO.
PROGRAM VERSION
TPCL VERSION
CG VERSION
CHINESE VERSION
CODEPAGE VERSION
BOOT VERSION
KERNEL FONT VERSION
WLAN MODULE
BLUETOOTH MODULE
[PARAMETERS]
HW DETECT
TONE ADJUST(T)
TONE ADJUST(D)
FEED ADJUST
CUT ADJUST
BACKFEED ADJUST
X-COORD. ADJUST
CODEPAGE
ZERO SLASH
FEED KEY
EURO CODE
CONTROL CODE
MAXI CODE SPEC.
SENSOR SELECT
PRINT SPEED
FORWARD WAIT
AUTO CALIB.
MULTI LABEL
AUTO THP CHK
BASIC
Reserved item1
Reserved item2
FLASH ROM
SDRAM
USB SERIAL NUM.
E2- 10

2.8 Self Print Test and Dump Mode Utilities

Print test label sample
28OCT2015B-FV4
15SEP2015 V1.4
27FEB2014 V1.0
27FEB2014 V1.0
27FEB2014 V1.0
V1.4
1.0.05
[Not installed]
[Not installed]
[0001110000100110]
[-03]
[+00]
[+0.0mm]
[+0.0mm]
[+0.0mm]
[+0.0mm]
[PC-850]
[0]
[FEED]
[B0]
[AUTO]
[TYPE 1]
[Transmissive]
[2ips]
[OFF]
[OFF]
[OFF]
[OFF]
[OFF]
[16MB]
[32MB]
[000000000001]
V1.6C