Toshiba B-EX6 Series Maintenance Manual page 106

5. SYSTEM MODE
[Values to be printed]
0 to 15
TAG CHECK [1] [2] [3]
[Description 1] Error tag detection
[Values to be printed 1]
OFF:
EPCCODE:
PASSWORD: Error tag detection is performed. Access password area is read before data write to
[Description 2] Password setting to protect error tag detection
Note: Only when "ON (ACCESS PASSWORD)" is selected for TAG CHECK
[Values to be printed 2]
OFF: Disabled.
ON: Enabled.
[Description 3] Auto unlock function
Note: Only when "ON (ACCESS PASSWORD)" is selected for TAG CHECK
[Values to be printed 3]
OFF: Disabled.
ON: Enabled.
MULTI WRITE [ ]
[Description] Hibiki tag multi-word write
[Values to be printed]
OFF: Disabled.
ON: Enabled.
CALIB. MODE [ ]
[Description] RFID calibration function
[Values to be printed]
OFF: Disabled.
ON: Enabled.
CALIB. AGC [ ]
[Description] Optimum AGC value obtained through RFID calibration
[Values to be printed]
0 to 15
CALIB. POSITION [ ]
[Description] Distance to the optimum read/write position obtained through RFID calibration
[Values to be printed]
-999.9mm to +999.9mm
ANTENNA POSITION [ ]
[Description] Combinational position of the RF antenna and the wave director
[Values to be printed]
FRONT: Front
CENTER: Center
REAR: Rear
SUCCEEDED TAGS
Error tag detection is not performed.
Error tag detection is performed. ID area data is read before data write to check for
error.
check for error.
Note: This value is valid only for GEN2 tags.
5-20
EO18-33031
5.4 DIAGNOSTIC