Toshiba B-EX6 Series Maintenance Manual page 146

5. SYSTEM MODE
WRITE AGC
RETRY MIN AGC
TAG CHECK
MULTI WRITE
CALIB. MODE
CALIB. AGC
CALIB. POSITION
ANTENNA POSITION
SUCCEEDED TAGS
VOID PRINT TAGS
<< RTC >>
Item
BATTERY CHECK
RENEWAL
 Settings not printed on the maintenance counter/parameter setting data printout
System mode:
<12>Z-MODE
Item
Z-MODE
User system mode:
<5>SHOW ISSUE COND.
Item
(Note)
Sensor
Mode
Print Speed
(Note)
Ribbon
Direction
(Note)
Media pitch
Print length
Print width
Media width
NOTE: Though the setting value is reset to the initial value by a parameter clear, the first online operation
after a parameter clear is performed based on the value set with the initial setting wizard.
AGC threshold for data write
AGC threshold lower limit for retry
RFID error tag detection
Hibiki tag multi-word write
RFID calibration mode
Optimum AGC value obtained through
RFID calibration
Distance to the optimum read/write
position obtained
calibration
Position of the RF antenna and the wave
director
Number of times data write succeeded
Number of times data write failed
Description
Battery check
Time update timing
5-60
0
0
Not cleared
OFF
OFF
0
+000.0mm
through RFID
Not cleared.
Not cleared.
Not cleared.
Initial value
Not cleared.
Not cleared.
Initial value
OFF
Initial value
TRANSMISSIVE
BATCH
203 dpi: 5 ips
305 dpi: 5 ips
RBN w/o save
BOTTOM
203 dpi: 76.0mm
305 dpi: 76.0mm
203 dpi: 74.1mm
305 dpi: 74.2mm
203 dpi: 160.0mm
305 dpi: 160.0mm
Not cleared
EM18-33031
5.8 RAM CLEAR