Toshiba B-EX6 Series Maintenance Manual page 21

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
Adjustment Method for B-EX6 TYPE3
Before installing the disk cutter unit for B-EX6 Type3, exchanging of Paper Guide and adjustment has to be
made to set the clearance of the cutter.
1. Loosen the two FL -3 x 6 screws holding the metal guide.
2. A Paper Guide is exchanged for Paper guide of Type3.
3. Prepare four sheets of Tag paper and insert them between the guides.
4. Press both sides of the Paper Guide against the 4 tag papers.
5. Tightened the SAME FL -3 x 6 screws after proper checking and adjustment is confirmed.
6. Perform a test cut to check for a proper operation. Repeat the procedure, if necessary.
FL -3x6 screws
FL -3x6 screws
Paper (Metal) guide
4- 4
(Revision Date: Mar. 1, 2017)
4.1 DISC CUTTER (B-EX206-QM-R)
4 Tag papers
1 tag paper = 0.15mm
4 tag papers= 0.6mm
EO18-33031