Calib. Agc; Calib. Position; Antenna Position - Toshiba B-EX6 Series Maintenance Manual

5. SYSTEM MODE

5.10.4.7 CALIB. AGC

By performing an RFID calibration, an AGC (response wave intensity from an RFID tag) value is
automatically obtained and set.
Max.
Min. value
value
15 0
NOTES:
1. This parameter is effective only when the CALIB. MODE parameter is set to ON.
2. Data write/read is performed only for the tags having the AGC value equal to or larger than the AGC
value set for this parameter. When the AGC value is less than the one set for this parameter, RFID
WRITE ERROR occurs.
3. For details of the RFID calibration, refer to Section 10.7 RFID CALIBRATION.
5.10.4.8

CALIB. POSITION

By performing an RFID calibration, an optimum data read/write position (distance from the home
position) is automatically obtained and set.
Max.
Min. value
value
+999.9 -999.9
NOTES:
1. This parameter is effective only when the CALIB. MODE parameter is set to ON.
2. The printer will automatically feed RFID media forward/backward for the distance specified by CALIB.
POSITION parameter before writing/reading RFID tag, which is normally performed with @003 command.
3. The feed direction is indicated by "+" (backward) and "
4. Setting values ranging from -2.9mm to +2.9mm do not reflect the read/write position fine adjustment.
5. For details of the RFID calibration, refer to Section 10.7 RFID CALIBRATION.

5.10.4.9 ANTENNA POSITION

This parameter, used for an RFID calibration, is to select the combinational position of the RF antenna
and the wave director.
・ FRONT
・ CENTER
・ REAR
<Combination of the RF antenna and the wave director>
Antenna position
FRONT
CENTER
REAR
NOTES:
1. A "usable" antenna position must be selected for this parameter.
2. If an RFID calibration is performed with "Unusable" antenna position selected, the printer operation is
not guaranteed. (Refer to Section 10.7.1 Outline of the RFID Calibration.)
3. For details of the RFID calibration, refer to Section 10.7 RFID CALIBRATION.
Step Display
1 Decimal
Step Display
0.1 Decimal
Antenna rotation
0°
Integer Decimal
Sign
digit
None 2
Integer Decimal
Sign
digit
None 3

" (forward).
Wave director position
0 mm
5-75
0-padding
place measure
0 None
0-padding
place measure
1 None
Application
Usable
Unusable
Unusable
EM18-33031
5.10 RFID
Unit of
None
Unit of
mm