System Mode; Outline Of The System Mode - Toshiba B-EX6 Series Maintenance Manual

5. SYSTEM MODE

5. SYSTEM MODE

5.1 OUTLINE OF THE SYSTEM MODE

1. The printer enters the system mode with the following operations.
 While the printer power is off, perform either of the following operations:
・ Turn on the printer while holding down the [FEED] and [PAUSE] key at the same time.
・ Turn on the printer while holding down the [MODE] key.
 While the printer is online, perform the following operation:
・ Hold down the [MODE] and [ENTER] keys at the same time for more than 3 seconds.
2. The system mode is intended for performing self-test and various parameter settings.
3. When the top menu is displayed, the main firmware version is shown on the right side of the title.
4. The language displayed on the LCD is Japanese when "Japanese" is selected for the LCD language
parameter, and English when a language other than "Japanese" is selected. (See <14>LCD PANEL.)
5. The key operations for the system mode are described below.
Top menu of the system mode
Display
SYSTEM MODE
▲
<0>RESET
<1>DIAGNOSTIC
<2>SET PARAMETERS
<3>TEST PRINT
▼
Top menu list
English
<0>RESET
<1>DIAG.
<2>SET PARAMETERS
<3>TEST PRINT
<4>SENSOR
<5>RAM CLEAR
<6>INTERFACE
<7>RFID
<8>RTC
<9>USB MEMORY
<10>FOR FACTORY
<11>BASIC
<12>EMULATION MODE
<13>XML
<14>LCD PANEL
<15>PASSWORD
C1.6
5-1
EO18-33031
(Revision Date: Nov., 2017)
5.1 OUTLINE OF THE SYSTEM MODE