Toshiba B-EX6 Series Maintenance Manual page 27

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
12. Insert the connector of the Harness Ass'y into the hole in the Main Frame, then fit the Cord Bush into
the hole.
NOTE: Make sure the wires will not touch or obstruct any moving parts.
13. Attach the Cutter Cover to the Cutter Unit with the Plastic Head Screws.
Plastic Head Screw
14. Close the Print Head Block and Print Head Block Holder Plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a failure of the
print head block or damage to the print head.
Harness Ass'y
Cutter Cover
4-10
Main Frame
Hole
Cord Bush
EO18-33031
4.1 DISC CUTTER (B-EX206-QM-R)