Toshiba B-EX6 Series Maintenance Manual page 235

13. PERIODIC MAINTENANCE PROCEDURE
6. Apply FLOIL HTM-308 to the cutter unit using a soft cloth.
CAUTION!
1. Lubrication: During parts replacement
2. Kinds of oil: FLOIL HTM-308: 1 Kg can. (Parts No. W0-00916000)
3. Do not spray the inside of the printer with lubricants. Unsuitable oil can damage the mechanism.
All machines are generally delivered in their best condition. Efforts should be made to keep them that
way. Lack of oil, or the presence of debris or dust, may cause an unexpected failure. To maintain in
optional operating condition, periodically clean the machine and apply the proper kind of oil to each part
in which lubrication is needed.
Although the frequency of lubrication varies according to how often the machine is used, as a minimum
it is necessary to lubricate before any part becomes dry. It is also necessary to wipe off excessive oil
or it will collect dirt.
7. Confirm that the problem occurs as reported, and then take corrective action.
8. Replace the following parts periodically, if necessary. The following table shows approximate product
life for each part.
No.
1 Cutter unit (Option: B-EX206-QM-R)
2 Platen
3 Feed Roller
4 Pinch Roller
NOTES: 1. The above values of the cutter life are obtained on condition that the periodically maintained
cutter is used with Toshiba Tec-approved supplies by the proper method described in the
manuals.
2. The above values differ depending on the thickness and substances of the media to be used.
When using the cutter to cut the labels, be sure to cut the backing paper. Failure to do this may
cause the glue to stick to the cutter and shorten the cutter life.
9. Confirm each part adjustment. Make any necessary adjustments.
Part Name
13. PERIODIC MAINTENANCE PROCEDURE
Standard interval of replacement
300,000 cuts
13- 3
(Revision Date: Mar., 2020)
50 km
50 km
50 km
EM18-33031