Toshiba B-EX6 Series Maintenance Manual page 85

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
2. Fasten the Harness Ass'y with the Cable Clamp.
3. Connect the Harness Ass'y to J11 on the Main PC board.
Main PC Board
Harness Ass'y
NOTE: Wind the Harness Ass'y around the cable clamp if the harness is too long.
4. Close the Print Head Block and Ribbon Shaft Holder Plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a failure of the print head
block or damage to the print head.
5. Re-install the Side Panel (L) and close the Top Cover.
6. Refer to the Service Manual for the parameter settings and check the cutter operation.
J11
Cable Clamp
4-68
(Revision Date: Dec., 2018)
4.9 4" ROTARY CUTTER (B-EX206-R-QM-S)
Cable Clamp
Harness Ass'y
EO18-33031