Toshiba B-EX6 Series Maintenance Manual page 66

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
Table 1 (Normal print)
A (mm)
10 to 20
over 20
Table 2 (Offset print)
A (mm)
10 to 20
over 20
- Offset printing Characteristics is the mode of execution of writing for one piece back word tag from the
printing Tag and it should be effective for plural RFID tag is printing continuously.
- When this function is enabled, the back feed to write data is unnecessary and the throughput should be
improved, due to the one piece back word Tag from printing label should be just on the RFID Antenna
when the around 20mm pitch tag is used.
- Offset printing function is available, when the @003 command (Writing before RFID ISSUE feed length
setting command)
C (mm) Antenna
10 to 18 Front
10 to 34 Front
34 to 41 Center
over 41 Rear
A+C (mm) Antenna
10 to 34 Front
34 to 38 Center
20 to 34 Front
34 to 41 Center
over 41 Rear
4.8 UHF RFID KIT (B-EX706-RFID-U4-US/EU/AU-R)
Shield Label Shielding plate
F
F
C
R
Shield Label Shielding plate
F
C
F
C
R
4-49
(Revision Date: Mar. 1, 2017)
Required
Disabled
Disabled
Disabled
Required
Disabled
Disabled
Disabled
Disabled
EO18-33031