Toshiba B-EX6 Series Maintenance Manual page 58

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
4.8.2 Mounting of the RFID Module
By RF label to be used, shield label (F/C/R), antenna position (front/middle/rear), different combinations of
the mounting of the shielding plate (Y/N). Please follow the combination described in "RFID label
recommended setting sheet".
1. Attach the selected Shield Label to the bottom of the Platen Holder Block.
Guide of Attachment Position
Attach the Shield Label along the rib.
<When viewed from the bottom>
Platen side
Actual view
2. Disconnect the shielding plate from the RFID module.
1. Remove the screws that secure
the antenna shield.
Rib
Shield Label
Platen
4-41
4.8 UHF RFID KIT (B-EX706-RFID-U4-US/EU/AU-R)
Platen Holder Block
CAUTION!
DO NOT DISASSEMBLE the Platen Holder Block.
Doing so will change the adjustment.
Antenna
2. Remove the screw holding the antenna
shield
EO18-33031
(Revision Date: Mar. 1, 2017)