Toshiba B-EX6 Series Maintenance Manual page 39

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
2. Secure the strip sensor (LED) to the Front Panel and strip sensor (Tr) to the Operation Panel with the
PT-3x6 screws. Then place the connected harnesses along the hook or clamp in the back side of the
Panel.
Strip Sensor (Tr)
Cable Hook
3. Fit the Operation Panel to the printer.
4. Connect the harnesses of the Strip Sensor (LED) and Strip Sensor (Tr) with the black connectors.
5. Connect the Strip Sensor (Tr) and the 4-pin connector of the Rewinder Harness.
4-pin Connector of the
Strip Sensor (Tr)
2-pin Connector of the
Strip Sensor (Tr)
NOTE: Make sure the wires will not touch or obstruct any moving parts.
Operation Panel
PT-3x6 Screw
Strip Sensor (LED)
PT-3x6 Screw
Front Panel (right)
4-22
4.3 PEEL-OFF MODULE (B-EX906-H-QM-R)
Front Panel (R)
Cable Clamp
4-pin Connector of the
Rewinder Harness
2-pin Connector of the
Strip Sensor (LED)
EO18-33031