Toshiba B-EX6 Series Maintenance Manual page 69

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
4.8.6.1 TEST
(1) ID READ
The printer enters the read test mode, and a read test is performed each time the [ENTER] key is pressed.
When the data of a tag can be read, it is displayed on the LCD.
▪ Only the tags selected for the RFID tag type can be read.
▪ The RFID tag type shall be selected before the read test is started.
▪ When the read test failed, the following message is displayed on the LCD:
Error message
MODULE TYPE ERROR
COUNTRY CONFIG ERROR
READ ERROR
Confirm Setting or Set other Tag
NOT AVAILABLE
NO RESPONSE
READ TIMEOUT
Set a RF-Tag on Ant.
UNKNOWN ERROR
▪ In the case of 32 digits or more data, only the first 32 digits are displayed. When data is less than 32
digits, the vacant digits will be filled with spaces
▪ If more than one tag is read at one time, especially when short-pitch tags are used, pressing the [UP] or
[DOWN] key shows the other tags' data.
4.8.6.2 MODULE
(1) MODULE TYPE
NONE: No RFID module is installed.

H1: not supported

H2: not supported

U2/U4: B-EX706-RFID-U4-US/EU/AU-R

U4 module preinstall model (B-EX6T1-GS18/TS18-CN-R)

NOTE: This setting will become effective after the printer power is turned off, and back to on.
(2) COUNTRY
The country code of the currently installed module is displayed.
If the module type is set to other than "U2", "INVALID" is displayed.
It is possible to change the country setting when the module type is set to "U2" and the actually installed
module type is U4-US or U4-EU. However, this menu is password-protected because changing the
country setting causes the output frequency to change.
B-EX706-RFID-U4-EU-R
B-EX706-RFID-U4-US-R
The number tag is being read./The total number of tags read
AGC value of the read tag
U4: EPC code in the EPC area is displayed in hex. value, up to
32 digits on 2 lines
(Example)
H1: Tag ID
EU0 (Europe) or IN0 (India Use of IN0 is prohibited.))
US (North America), AU (Australia), KR2 (Korea) CN2 (China), Use of CN2, US
and AU are prohibited.
4.8 UHF RFID KIT (B-EX706-RFID-U4-US/EU/AU-R)
Description
RFID module type has been set to NONE or a communication
cannot be established.
Country code has not been set.
The type of the tag to be read and one selected by the RFID tag type
selection do not match.
Not supported.
No response from the tag
Timeout
Other errors
4-52
EO18-33031
(Revision Date: Mar. 1, 2017)