Setup Mode Screens; Password Screen; System Screen 1 - Graco ProMix PD2K Operation

Setup Mode Screens

Setup Mode Mode Screens
Setup Setup Mode
Press on any Run screen to enter the Setup
screens.
Most parameters on the Setup screens may be
configured individually for each Mix Unit, while some
are global. Those that may be set individually appear
in two columns.
NOTE: NOTE: NOTE: Selection fields and buttons that are
grayed-out on the screens are not currently active.
If the system has a password lock, the Password
screen displays. See Password Screen, page

Password Screen

Screen
Password Password Screen
Figure 36 Password Screen
Enter the 4 digit password, then press
screen 1 will open, allowing access to the other
Setup screens.
Entering an incorrect password clears the field.
Reenter the correct password.
To assign a password, see
Advanced Screen 1, page
68
Screens
Screens
68.
. System
92.
System Screen Screen 1 1 1
System System Screen
System screen 1 includes the following fields which
define your system.
Figure 37 System Screen 1, During Standby
Diagnostic Mode Mode
Diagnostic Diagnostic Mode
Select this box to display flow rate and pressure for
each pump on the Home Screen, page
Recipe Linking Linking
Recipe Recipe Linking
Select this box to enable recipe linking on the
Recipe Screen, page 76.
Manual Override Override
Manual Manual Override
Check this box to give users system control at the
ADM. Leave the box unchecked if all system settings
are controlled through a PC, PLC, or other networked
device.
Solvent Meter Meter
Solvent Solvent Meter
Select this box if your system uses a solvent meter.
The Solvent K-Factor field will then become active.
61.
3A4486D