Graco ProMix PD2K Operation page 64

Run Mode Screens
Spray Screen Screen
Spray Spray Screen
NOTE: In normal operating mode, controlled by a
NOTE: NOTE:
PLC, the Spray Screen is display only. No changes
can be made. This section provides information
about the Spray Screen if Manual Override is enabled
on System Screen 1, page
system in Manual Override mode.
The Spray screen includes the following information
for the selected Mix Unit:
• Active Recipe (can be changed on this screen)
• Target Ratio (not shown in 1K Mode)
• Actual Ratio (not shown in 1K Mode)
• Target Pressure (if Pressure Mode is selected on
System Screen 4) or Target Flow (if Flow Mode is
selected). Target pressure or flow can be changed
on this screen).
• Actual Pressure
• Actual Flow
• Potlife Remaining
• Gun Animation
In addition, the Spray screen includes four soft keys:
Press to put the system in
Standby.
Press to spray mixed material.
Press to purge the gun.
Press to switch between Mix
Units.
When the system is configured for solvent push, the
purge soft key changes to the solvent push soft key
while in Mix mode.
Press to initiate solvent push.
Figure 20 Spray Screen, in Standby Mode
64
68. The screens show a
Figure 21 Spray Screen, in Mix Mode
Figure 22 Spray Screen, in Idle Mode
Figure 23 Spray Screen, in Mix Mode, Solvent Push
Enabled
3A4486D