Graco ProMix PD2K Operation page 79

Flush Screen Screen
Flush Flush Screen
Figure 51 Flush Screen
Flush Number Number
Flush Flush Number
Enter the desired flush sequence (1-5). For hard
to flush colors, select a longer sequence. 1 is the
default, and should be designated for the longest,
most thorough flush duration.
Air/Solvent Chop Chop
Air/Solvent Air/Solvent Chop
This option is available if Mix At Wall is enabled on
System Screen 3, page
chop for flushing the gun rather than just a solvent
purge. See Air/Solvent Chop, page
Air and solvent chop may also be enabled for flushing
out a pump. See Custom Valve Mapping, page
for more information.
3A4486D
70. Enable an air and solvent
80.
NOTE: Air/solvent chop requires additional hardware NOTE: NOTE:
for the air purge valve. See manual 333282 for kit
numbers and installation details.
Initial Flush
Initial Initial
Enter the initial flush volume (0 to 9999 cc).
Wash Cycles
Wash Wash
A Wash Cycle activates the pump with the valves
closed, to use pumping motion to thoroughly clean
the pump. Enter the desired number of wash cycles
(0 to 99). Entering a number will make the Strokes
per Cycle field active.
Strokes per
Strokes Strokes
Enter the desired pump strokes per wash cycle (0
to 99). Default is 1.
Final Flush
Final Final
Enter the final flush volume (0 to 9999 cc).
Gun Purge Purge Time
Gun Gun Purge
Enter the spray device purge time (0 to 999 seconds).
82,
Setup Mode Screens
Flush
Flush
Cycles
Cycles
per Wash Wash Cycle Cycle
per Wash Cycle
Flush
Flush
Time
Time
79