Color Change - Graco ProMix PD2K Operation

Color Change

Color Change Change
Color Color Change
Color Change Module Kits are available as an
accessory. See manual 333282 for complete
information.
Multiple Multiple Color Multiple Color Systems Color Systems Systems
1. Command the system to Standby.
2. Enable manual override on
System Screen 1, page
98
68.
3. Select the new recipe on the
Spray Screen, page
colors in the pump and initiate a gun purge.
4. The system will purge material B then material
A out of the gun. Each material will purge for
the amount of time designated by the Flush
Sequence selected for each material on the
Recipe Screen, page
5. Wait for the color change to complete. The
system automatically goes from Color Change to
Mix Fill and the remote mix manifold automatically
selects the correct color.
6. Trigger the gun to complete the Mix Fill.
NOTE: There is a 10 second delay without flow
NOTE: NOTE:
before the system will fault.
7. Wait for the system to complete the Mix Fill
operation. Command the system to Mix and
begin spraying..
64. This will change
76.
3A4486D