Pre-Operation Tasks
Initial System
System Setup
Setup
Initial
Initial
System
Setup
1. Change optional setup selections to
desired parameters, as described in
Setup Mode Screens, page
2. Set recipe and flush information as
described in
Recipe Screen, page
and
Flush Screen, page
Flush
Flush Before
Flush
Before Using
Before
Using Equipment
Using
The pump fluid section was tested with lightweight
oil, which is left in the fluid passages to protect parts.
To avoid contaminating your fluid with oil, flush the
equipment with a compatible solvent before using
the equipment.
18
68.
76,
79.
Equipment
Equipment
Valve Settings
Settings
Valve
Valve
Settings
Dose valves and purge valves are factory set with the
hex nut (E) 1-1/4 turns out from fully closed.
Figure 10 Valve Adjustment
3A4486D