Graco ProMix PD2K Operation page 90

Setup Mode Screens
Maintenance Screens Screens
Maintenance Maintenance Screens
Maintenance Maintenance Screen Maintenance Screen Screen 1 1 1
Use this screen to set maintenance intervals. Set
to 0 to disable the alarm.
NOTE: NOTE: The Pump Stall Test cannot be disabled. You NOTE:
must enter a value other than 0.
Figure 74 Maintenance Screen 1, Interval Settings
Maintenance Screen Screen 2 2 2
Maintenance Maintenance Screen
Maintenance screen 2 shows the current interval
status of the solvent meter, fluid filter, and air filter.
Press and hold the Reset button
seconds to clear the alarm and reset the counter.
Figure 75 Maintenance Screen 2, Current Status
Solvent Solvent Solvent Meter Meter Meter
If two solvent meters are used, enter the desired
solvent meter number.
90
for 1-2
Maintenance Screen Maintenance Maintenance Screen 3 3 3 Screen
Maintenance screen 3 shows the current interval
status of the pump maintenance tests.
Press and hold the Reset button
seconds to clear the alarm and reset the counter.
NOTE: The Pump Stall Test can only be reset by NOTE: NOTE:
successfully completing the test.
Figure 76 Maintenance Screen 3, Current Pump
Status
for 1-2
3A4486D